Victron Energy MultiPlus-II 48/3000/35-50 120V + PYTES V16

What you'll set up yourself

1. Ask PYTES whether this battery can run without communication. Their documents don't say.
2. Enter the battery's charge settings on the inverter by hand, in the battery settings described in the inverter's manual.
   • Max charge current: no more than 200 A per battery, from the battery's spec sheet.
   • Charge voltage, float voltage, and low-voltage cutoff: from the PYTES V16 manual.
3. Closed-loop communication needs an extra part: Victron GX device (e.g. Cerbo GX) for BMS-Can or a Lynx Smart BMS.

Published limits, side by side

Values come from each maker's documents. "Not published" means the maker doesn't state it.

Confirm with the makers before you buy

• Each product's current limits. One or both aren't published, so ask both makers.
• Which firmware versions support this pairing. We don't track firmware.
• That your cable lugs fit the inverter's battery studs (M8) and the battery's terminals (Phoenix Plug & Play DC Connector (Model: BPC 250 FT B 35-70)).
• How to install both safely, from each maker's manual and your local code.

This result checks two things: the battery's voltage suits the inverter, and the inverter maker lists this battery for closed-loop communication (the battery tells the inverter how to charge it). It doesn't check current limits, charge settings, firmware, cable sizes, or safe installation. Confirm those with both makers before you buy.

Sources

This result comes from the documents below. We haven't yet found an outside source that confirms it, such as a forum report or a video of a real install.

• Victron Energy MultiPlus-II 48/3000/35-50 120V spec sheet · manual
• PYTES V16 spec sheet · manual