Schneider Electric SW 4048 120/240 + EG4 WallMount Indoor 280Ah

What you'll set up yourself

1. Ask EG4 whether this battery can run without communication. Their documents don't say.
2. Enter the battery's charge settings on the inverter by hand, in the battery settings described in the inverter's manual.
   • Max charge current: no more than 140 A per battery, from the battery's spec sheet.
   • Charge voltage, float voltage, and low-voltage cutoff: from the EG4 WallMount Indoor 280Ah manual.

Published limits, side by side

Values come from each maker's documents. "Not published" means the maker doesn't state it.

Confirm with the makers before you buy

• Whether one battery can take the inverter's full current. The inverter's max battery current is 110 A. This battery is rated for 140 A charging and 140 A output. Ask how many batteries to run in parallel.
• Which firmware versions support this pairing. We don't track firmware.
• That your cable lugs fit the inverter's battery studs (3/8 in) and the battery's terminals (Not published).
• How to install both safely, from each maker's manual and your local code.

This result checks two things: the battery's voltage suits the inverter, and the inverter maker lists this battery for closed-loop communication (the battery tells the inverter how to charge it). It doesn't check current limits, charge settings, firmware, cable sizes, or safe installation. Confirm those with both makers before you buy.

Sources

This result comes from the documents below. We haven't yet found an outside source that confirms it, such as a forum report or a video of a real install.

• Schneider Electric SW 4048 120/240 spec sheet · manual
• EG4 WallMount Indoor 280Ah spec sheet · manual