Needs manual setup

SOL-ARK 12K-2P-LL + SimpliPhi Power PHI-3.8-48-60

Checked automatically against spec sheets. Not yet confirmed in a real install. Last checked 2026-10-12. We don't track firmware versions.

What you'll set up yourself

  1. Enter the battery's charge settings on the inverter by hand, in the battery settings described in the inverter's manual.
    • Max charge current: no more than 37.5 A per battery, from the battery's spec sheet.
    • Charge voltage, float voltage, and low-voltage cutoff: from the SimpliPhi Power PHI-3.8-48-60 manual.

Published limits, side by side

Spec SOL-ARK 12K-2P-LL SimpliPhi Power PHI-3.8-48-60
Voltage 48 V accepts 43–59 V 51.2 V
Current Max battery current 220 A Max charge 37.5 A Max output 37.5 A Peak output 80 A
Communication Sol-Ark closed loop Open loop (no comms)
Cable connection Stud size Not published Terminal 3/8 IN (10 mm)

Values come from each maker's documents. "Not published" means the maker doesn't state it.

Confirm with the makers before you buy

This result checks two things: the battery's voltage suits the inverter, and the inverter maker lists this battery for closed-loop communication (the battery tells the inverter how to charge it). It doesn't check current limits, charge settings, firmware, cable sizes, or safe installation. Confirm those with both makers before you buy.

Sources

This result comes from the documents below. We haven't yet found an outside source that confirms it, such as a forum report or a video of a real install.

Where to buy

SOL-ARK 12K-2P-LL

SimpliPhi Power PHI-3.8-48-60

Spot a mistake? Email errata@offgridstacks.com with this page's link.